# New HyperPixel Display (non-touch) stopped working

**URL:** <https://forums.pimoroni.com/t/new-hyperpixel-display-non-touch-stopped-working/8631>\
**Category:** Support\
**Created:** [September 6, 2018, 10:04pm UTC](https://forums.pimoroni.com/t/new-hyperpixel-display-non-touch-stopped-working/8631 "2018-09-06T22:04:34Z")\
**Posts on this page:** 1\
**Page:** 1

<div class="post-metadata">

**Author:** ![defsdoor](https://avatars.discourse-cdn.com/v4/letter/d/b5a626/32.png) [@defsdoor](https://forums.pimoroni.com/u/defsdoor)\
**Post date:** [September 6, 2018, 10:04pm UTC](https://forums.pimoroni.com/t/new-hyperpixel-display-non-touch-stopped-working/8631/1 "2018-09-06T22:04:34Z")

</div>

Hi

I got a new pi and hyperpixel display today and set it all up ok but at some point it’s stopped displaying any output.

I’m running non-gui, and my /boot/config.txt looks ok.

The backlight is lit and when rebooting it appears to do a screen “reset” where all pixels are set (except periodic vertical lines) but I don’t get any console output or ultimately login.

The pi is booting ok. There are no hyper\* related messages in syslog.

Any ideas or is it faulty ?

Non-commented out lines in /boot/config.txt. -

dtparam=audio=on

dtoverlay=hyperpixel  
overscan\_left=0  
overscan\_right=0  
overscan\_top=0  
overscan\_bottom=0  
framebuffer\_width=800  
framebuffer\_height=480  
enable\_dpi\_lcd=1  
display\_default\_lcd=1  
dpi\_group=2  
dpi\_mode=87  
dpi\_output\_format=0x6f016  
display\_rotate=2  
hdmi\_timings=800 0 50 20 50 480 1 3 2 3 0 0 0 60 0 32000000 6