# Speaker phat not working (again?)

**URL:** <https://forums.pimoroni.com/t/speaker-phat-not-working-again/8424>\
**Category:** Support\
**Created:** [August 19, 2018, 4:24pm UTC](https://forums.pimoroni.com/t/speaker-phat-not-working-again/8424 "2018-08-19T16:24:22Z")\
**Posts on this page:** 2\
**Page:** 1

<div class="post-metadata">

**Author:** ![veryalien](https://sea2.discourse-cdn.com/flex016/user_avatar/forums.pimoroni.com/veryalien/32/2769_2.png) [@veryalien](https://forums.pimoroni.com/u/veryalien)\
**Post date:** [August 19, 2018, 4:24pm UTC](https://forums.pimoroni.com/t/speaker-phat-not-working-again/8424/1 "2018-08-19T16:24:23Z")

</div>

After struggling to get my speaker phat working a few months ago it’s now either died, or something’s changed in the software/distribution.  
It’s the ‘usual’ problem of no sound but the vu meter leds are working fine.  
Absolutely silent on boot, no clicks, nothing. That’s suspicious because it used to click a few times during booting.  
aplay -l says no soundcards found.  
Stopping pulseaudio has no effect (not a surprise).  
The test.sh script says file not found because there’s no audio device and the only thing that works are the leds.  
I swear it was working ok, sound and everything, together with a load of other phats on my phat stack.  
Reinstalling the speaker phat config, software and python library using the curl one-liner didn’t fix it. Config, from what I remember, and from the other forum threads seems ok.  
Installing for the first time on a pi3b+ has exactly the same problem, which could mean it’s dead.  
I’ve even resoldered the gpio header on the speaker phat in a desperate attempt to get it working, but no joy there.  
The hifiberry-dac appears in the lsmod list, so I assume it’s getting loaded correctly. Has anything changed in the dac or raspbian?  
Has anyone tried using or installing a speaker phat recently with an up-to-date raspbian?  
How could I tell if the dac hardware is probably still working or if it’s just dead?  
Or what (stupidly obvious) thing have I forgotten?

Edit: No, I haven’t done a clean install on a new raspbian sd card. I’m getting annoyed with that as a possible solution…

---

<div class="post-metadata">

**Author:** ![alphanumeric](https://sea2.discourse-cdn.com/flex016/user_avatar/forums.pimoroni.com/alphanumeric/32/2729_2.png) [@alphanumeric](https://forums.pimoroni.com/u/alphanumeric)\
**Post date:** [August 19, 2018, 7:57pm UTC](https://forums.pimoroni.com/t/speaker-phat-not-working-again/8424/2 "2018-08-19T19:57:23Z")

</div>

The SN3218 LED driver uses i2c. The sound is I believe is I2S. Not sure how you check or test that though?  
Pinout is here, [https://pinout.xyz/pinout/speaker\_phat#](https://pinout.xyz/pinout/speaker_phat#) if that helps. Kind of sounds (no pun intended) like its failed?
