No sound from Pirate Radio after installing spotipy script

Support
3

ok…here goes…

cat /etc/asound.conf

pcm.!default {
        type plug
        slave.pcm {
                type meter
                slave.pcm "softvol"
                scopes.0 pivumeter
        }
}

ctl.!default {
        type hw
        card 0
}

pcm.dmixer {
        type dmix
        ipc_key 1024
        ipc_perm 0666
        slave.pcm 'hw:0,0'
        slave {
                period_time 0
                period_size 1024
                buffer_size 8192
        }
        bindings {
                0 0
                1 1
        }
}

ctl.dmixer {
        type hw
        card 0
}

pcm.softvol {
        type softvol
        slave.pcm "dmixer"
        control {
                name "PCM"
                card 0
        }
}

pcm_scope.pivumeter {
        type pivumeter
        decay_ms 500
        peak_ms 400
        brightness 128
        output_device phat-beat
}

pcm_scope_type.pivumeter {
        lib /usr/local/lib/libpivumeter.so
}

pcm.pivumeter {
        type meter
        slave.pcm 'hw:0,0'
        scopes.0 pivumeter
}

pcm.dsp0 pivumeter

and

cat /boot/config.txt

# For more options and information see
# http://rpf.io/configtxtreadme
# Some settings may impact device functionality. See link above for details

# uncomment if you get no picture on HDMI for a default "safe" mode
#hdmi_safe=1

# uncomment this if your display has a black border of unused pixels visible
# and your display can output without overscan
#disable_overscan=1

# uncomment the following to adjust overscan. Use positive numbers if console
# goes off screen, and negative if there is too much border
#overscan_left=16
#overscan_right=16
#overscan_top=16
#overscan_bottom=16

# uncomment to force a console size. By default it will be display's size minus
# overscan.
#framebuffer_width=1280
#framebuffer_height=720

# uncomment if hdmi display is not detected and composite is being output
#hdmi_force_hotplug=1

# uncomment to force a specific HDMI mode (this will force VGA)
#hdmi_group=1
#hdmi_mode=1

# uncomment to force a HDMI mode rather than DVI. This can make audio work in
# DMT (computer monitor) modes
#hdmi_drive=2

# uncomment to increase signal to HDMI, if you have interference, blanking, or
# no display
#config_hdmi_boost=4

# uncomment for composite PAL
#sdtv_mode=2

#uncomment to overclock the arm. 700 MHz is the default.
#arm_freq=800

# Uncomment some or all of these to enable the optional hardware interfaces
#dtparam=i2c_arm=on
#dtparam=i2s=on
#dtparam=spi=on

# Uncomment this to enable the lirc-rpi module
#dtoverlay=lirc-rpi

# Additional overlays and parameters are documented /boot/overlays/README

# Enable audio (loads snd_bcm2835)
#dtparam=audio=on
dtoverlay=i2s-mmap
dtoverlay=hifiberry-dac

Thanks

Pimusicbox on pirate radio