Hi,
sorry my bad english, (an old german boy ) -:)
First many thanks for the postings about OnOff SHIM.
I bought this one and it`s work fine.
But , one question:
Its possible to bring on an external buttom with the same funktion, and its possible to take some PIN`s of the PI 3 Board?
Thank`s for the help
best regards
Steffen
You can wire up your own button to the two solder pads next to the BTN on the board. You want a normally open momentary contact button. Something like this will work, https://shop.pimoroni.com/products/colourful-arcade-buttons or https://shop.pimoroni.com/products/mini-arcade-buttons.
The pinout is here, https://pinout.xyz/pinout/onoff_shim# You can use any of the other GPIO not used by the on off shim.
You could use those points if you wanted, the ones I was talking about are in the lower left, opposite corner, where it says Button. The two pads right under the word BUTTON.
Ah, Ok Ive understood. Thanks so lot for your help.
Best regards from old germany.
Steffen -:)
Klappt. Fantastisch. Lesen geht über probieren !!!
Works. Fantastic. Reading is about to try !!!
